T01126en.fm 49
Starting up
Stand squarely and set the cut-off saw onto the ground so that the cut-
ting attachment is freestanding.
Move the protective hood (3) to the best position for the application at
hand (see figure).
Grab the handle (2). The protective hood (3) can be swivelled within
the stopmounts in both arrow directions.
Notice:
Make absolutely sure that the straight edge of the stop plate (4) is par-
allel to the edge of the protective hood (see arrows).
If this is not the case, please take your machine to the shop.
7.6.1 Cold start
Press the multifunction switch (6) upward (choke position).
Put your hand around the handle (safety switch (8) is actuated by the
palm of your hand).
Press the throttle lever (9) all the way through and hold it.
Press the lock button (7) and release the throttle lever (9) (throttle lever
is locked in place by the lock button in the half-gas position). Press in
the start valve (5).
41
42
To Next Page
Loading...
Need help?
General
