Starting up
T01126en.fm 52
The following steps are required to correctly set the idle speed:
Start the engine and let it warm up (approx. 3 - 5 minutes).
Set the speed for the idle position with the screwdriver that was includ-
ed in delivery.
Readjust the idle speed
If the cutting blade rotates when the engine is running, screw the stop
screws (2) for the choke outward until the cutting blade no longer ro-
tates. If the emgine stops when idling, turn the screw back in some-
what.
Turn off the engine
46
47
To Next Page
Loading...
