Wacker Neuson DPU 130Le User Manual

3 Using the configuration menu DPU 130
16 Machine configuration manual
3.2 Changing from numerical code display to language display
Note: The meaning of the numerical codes is given in the appendix of the
operator's manual.
The following steps are necessary to switch from numerical code display back to
language display:
1. Activate machine.
2. Turn on remote control.
3. Hold the ON/OFF switch on the machine at the same time as the Stand
vibration button on the remote control for at least 3 seconds.
4. If the following text appears on the display screen, enter the setup PIN using
the remote control and then confirm with the ON/OFF switch:
 Push the left control lever on the remote control forward or backward to select
the position.
 Push the right control lever on the remote control forward or backward to
select the number.
5. Press the ON/OFF switch on the machine until the following text appears on
the display screen:
6. After approx. 2 seconds the following text appears on the display and you can
set the language:
 Push the right control lever on the remote control forward or backward to
select the number.
32
0000
3
20
20
4

Wacker Neuson DPU 130Le Specifications

General

Brand	Wacker Neuson
Model	DPU 130Le
Category	Industrial Equipment
Language	English