Maintenance
T00997GB.fm 37
5.3 Batterry
5.3.1 Check acid level:
1. Remove battery cover.
2. Check acid level, if necessary top up with distilled water.
3. Secure battery cover.
Do not close venting opening!
Note: Only replace defective batteries with original Wacker batteries.
Standard batteries are not suitable for the high vibration loads.
4. When changing the battery:
Removal: First disconnect negativ, then positive terminal of battery.
Assembly. First connect positive, then negative terminal of battery.
When using starting sprays etc., see chapter operation.
To Next Page
Loading...
