6-8 BA D18 us* 1.1 * D18t600.fm
6 Transportation
1. Empty the skip and lower it to middle position.
2. Remove all dirt from the machine.
3. Park the machine on firm, level and horizontal ground.
4. Lock the control lever – see chapter “ Enabling/disabling the operating
hydraulics” on page 5-10.
5. Stop the engine.
6. Remove the starting key and carry it with you.
7. Machine with optional cabin:
- Safely store all loose objects.
- Close and lock all covers and the door.
8. The rollbar can be lowered to reduce the transport height –
see chapter “ Rollbar” on page 4-13
9. Put the center-pivot prop in place – see “Center-pivot prop” on
page 6-6.
10.Use suitable lifting gear (chain, etc.).
11.Put the lifting gear through bracket A on the edge of the skip and
fasten it on lifting eyes B on the left and right on the chassis with
suitable slings.
12.Slowly raise the machine until there is no more contact with the
ground.
13.Wait until the machine does not swing any more.
14.If the machine balance, and the condition and position of the slings is
correct, slowly raise the machine to the required height and load it.
The manufacturer’s warranty shall not apply to accidents or damage
caused by loading or transporting.
To Next Page
Loading...
