BA EZ17 en* 1.1 * ez17w700.fm 7-21
Maintenance 7
Damage to surface due to centering D on lower side.
► Raise the canopy sufficiently as you remove it.
10.Raise the canopy from the anchoring.
11.Swivel the revolving superstructure about 10° to the right to improve
access to screws E.
12.Remove the screws E on the left and right.
13.Raise as follows:
- Raise the control lever base.
- Remove the starting key and carry it with you.
- Get out of the canopy.
- Close and lock the engine cover and the other covers.
- Remove loose objects from inside the machine.
- Wait until the canopy does not swing any more and is completely
steady.
14.Set down the canopy safely and ensure that it cannot tip over.
Assembly
1. Tighten the screws E slightly.
Danger of crushing due to pre-tensioned canopy!
The pre-tensioned canopy can cause serious injuries.
► Pay attention to the movements of the pre-tensioned canopy as you
install the screws.
Damage to surface due to centering D on lower side.
► Raise the canopy sufficiently as you install it.
To Next Page
Loading...
