Wacker Neuson E16-02

BA E16 en* 1.0 * E16_10_510.fm 5-53
Operation 5
Connecting and disconnecting hydraulic couplings
1. Stop and park the vehicle – see chapter “ Preparing lubrication” on
page 7-9.
2. Position the boom straight ahead at the center of the vehicle.
3. Lower the stabilizer blade to the ground.
4. Turn the starting key to position 1.
5. Move the control lever or the pedal of the hydraulic circuit in all
directions repeatedly.
6. Remove the starting key and carry it with you.
➥ The grab hose couplings can now be coupled and uncoupled from the
couplings.
Hydraulic connections
Information
Follow the instructions in the operator’s manual of the attachment
manufacturer for connecting the hydraulics to the attachment.
Fig. 217
A
B
C
Connec-
tion
Stick (left/right)
A AUX V (option)
B AUX II or AUX III (option)
C AUX I
D Hydraulic thumb (option)
Fig. 218
C
AB
Fig. 219
D