T00122GB
6
DESCRIPTION
Application
This versatile breaking and drilling hammer is used in civil engineering and building industry, in concrete works,
cast stone plants, foundries, by plumbing installation firms and communities. It is particularly suited for use on
natural and cast stone, as well as for all kinds of brickwork and concrete. A wide selection of easily interchange-
able tools is available for drilling holes from 12 to 125 mm, for breaking, chiselling, digging, puddling, hammer-
ing ramming and deburring.
Putting into operation
1. Attachment of the tool
* Snap out holder spring.
* Insert tool as far as it will go.
* Only use sharp tools.
* Snap back holder spring.
Use tools with shanks in proper condition to eliminate rebound blows. It is recommended to slightly grease
or oil the tool shanks and tool holder bushing to avoid dry operation resulting in seizure.
2. Connectionn
This electric hammer is powered by 230/240 V, A. C. (single phase). A suitable plug is provided for connec-
tion.
During operation
1. Changing the application
The position for breaking or drilling is indicated by the arrow on the cylinder housing and the respective sym-
bol situated opposite on the control lever. To change application turn lever 1/2 turn to the next notch.
2. Speed control
To reduce the power of the hammer turn knurling wheel in handle in anti-clockwise direction (-). Turn wheel
as far as it will go. (Operation at reduced power is necessary for spot drilling and for work on brittle material).
To set hammer to full power turn knurling wheel in clockwise driection (+).
3. Lock button
Lock control lever by means of lock button when using the hammer for long breaking operations. When
pression on control tongue, lock button i released.
☛ATTENTION! Do not use lock button for drilling jobs!
4. Handle at tool holder
Can be turned 360
o
according to need; tighten strongly with supplied tommy ban before starting work.
To Next Page
Loading...
Need help?
General
