What to do if my Wacker Neuson Power Tool is not in operation?
If your Wacker Neuson Power Tool is not in operation, the power cable may be interrupted or the rotor may be defective. Check the power cable and replace it if it is defective. If the power cable is not the issue, have the rotor replaced.
What to do if the percussion system of my Wacker Neuson Power Tool is blocked?
If the percussion system of your Wacker Neuson Power Tool is blocked, it could be due to ice formation from very low temperatures or seizing of moveable parts. If ice formation is the cause, allow the machine to warm up in a warm environment, such as a heated room. If the issue is due to the seizing of moveable parts, have the defective components replaced.
What to do if the drill is jammed in my Wacker Neuson Power Tool (EHB 7)?
If the drill is jammed in your Wacker Neuson Power Tool (EHB 7), it could be due to too much borer dust in the borehole or interfering reinforcing steel. If there is too much borer dust, pull the drill bit out of the borehole and remove the dust from the drill bit. If interfering reinforcing steel is the cause, redrill the borehole.
What to do if my Wacker Neuson EH 6 Tools drill is jammed (only EHB 7)?
If your Wacker Neuson Tools drill is jammed, especially model EHB 7, it could be due to too much borer dust in the borehole. Try pulling the drill bit out and removing the dust. Alternatively, the drill might be hitting reinforcing steel; in this case, you should redrill the borehole.
How to fix a blocked percussion system in Wacker Neuson Tools?
A blocked percussion system in your Wacker Neuson Tools could be due to: * Ice formation from low temperatures: Allow the machine to warm up in a heated room. * Seizing of moveable parts: Have the defective components replaced.
General| Brand | Wacker Neuson |
|---|---|
| Model | EH 6 |
| Category | Tools |
| Language | English |
To Next Page
