EHB 11 Operation
25
7.2 Adjusting the machine
7.2.1 Operating mode
Selecting the operating mode
Check position of adjusting lever for chiseling/hammer drilling.
Adjust the position of the chiseling/hammer drilling adjusting lever to meet the
needs of the respective application:
f Rotate the chiseling/hammer drilling adjusting lever a half a turn until lever
locks into place.
WARNING
Starting the machine during switching!
Danger of injury with uncontrolled start up.
f Actuate adjusting lever for chiseling/hammer drilling only after machine has
come to a complete standstill.
Item Designation
1 Adjusting lever for chiseling/
hammer drilling
To Next Page
Loading...