BA ET18, 20, 24 en* 1.5 * et18_20_24w700.fm 7-17
Maintenance 7
Removing/installing the cabin/canopy
Danger of accidents when performing machine travel without cabin/
canopy!
Causes serious injury or death.
► Performing machine travel with a removed cabin/canopy is only
allowed for performing machine travel over very short distances.
► Fastening the seat belt is prohibited.
► Do not perform any work without a cabin/canopy.
► Obtain the approval of the appropriate national authority.
► Machine travel is only allowed on level ground.
► Avoid tipping movements of the machine under all circumstances.
► Machine travel in areas involving a risk of falling objects is prohibited.
Check for damage as you raise the machine.
► Slowly raise the cabin.
► Wait until the machine does not swing any more.
► The lifting gear must not chafe or touch glass surfaces.
1. Stop and park the machine. Stop the engine. See “Preparing
lubrication”.
2. Open the engine cover.
3. Remove shackle A in the engine compartment.
4. Remove the rear roof lights (option).
5. Install shackle A and tighten the screw to 45 Nm (33.2 ft.lbs).
Fig. 242Engine compartment shackle
A
To Next Page
Loading...
