Disassembly/Assembly Procedures GP Repair
wc_tx000549gb.fm 110
7.5 Replacing the Muffler
See Graphic: wc_gr003136
Removal:
7.5.1 Disconnect the spark plug.
7.5.2 Remove the screw (a) that secures the muffler guard and the
generator mounting leg (b) to the shock mount bracket.
7.5.3 Remove the screws (c) that secure the muffler guard to the frame.
7.5.4 Remove the six screws (d) that secure the muffler guard halves
together and remove the outer muffler guard (e).
Note: For clarity, the engine and muffler are shown removed from the
generator frame.
7.5.5 Remove the two nuts (f) that secure the muffler to the engine and
remove the muffler and the inner muffler guard (g) from the engine.
Installation:
7.5.6 When installing the muffler, the inner muffler guard (g) will need to be
positioned before installing the two nuts that secure the muffler to the
engine. To do so, slide the inner muffler guard over the muffler.
Position the inner guard so that the muffler is able to mate with the
gasket and engine exhaust manifold. Then, using two nuts (f), secure
the muffler and the inner muffler guard to the engine.
7.5.7 Secure the outer muffler guard (e) to the inner muffler guard with six
screws (d).
7.5.8 Install the screws (c) that secure the muffler guard to the frame.
7.5.9 Secure the muffler guard and the generator mounting leg to the shock
mount bracket using screw (a) and nut.
7.5.10 Reconnect the spark plug.
To Next Page
Loading...
Need help?
General
