11
11
Index
Contents
Index
Contents
Interactive pen display
INSTALLATION
The computer treats the interactive pen display as two separate devices (the display and the pen tablet).
Therefore, the installation process is completed in two stages:
• First install as a display.
• Then install as a pen tablet.
Both stages require hardware and software installations and adjustments. Carefully follow ALL
instructions.
Important: You MUST install the Wacom driver software for correct pen-on-screen functionality.
System requirements
Step 1: Pen display installation
Step 2: Pen tablet installation
SYSTEM REQUIREMENTS
Make sure your computer meets the following minimum system requirements:
• PC. Windows 8, Windows 7, Vista™, or XP (32 and 64 bit). Available USB port, and CD-ROM drive.
• Macintosh. OS X, v10.6 or greater. Available USB port, and CD-ROM drive.
Note: Wacom recommends that you use both of these USB connectors to ensure adequate power for the
pen display. However, your system may operate satisfactorily with just one USB connector attached
to your computer.
To Next Page
Loading...
Need help?
General
