To Next PageTo Next PageWhat to do if Waeco ASC1300G Air Conditioner displays “Warning! Internal vessel over- pressure!”?
This message appears during the recycling process. To continue, press ENTER for three seconds. If the message appears repeatedly, contact customer services.
Why does my Waeco ASC1300G Air Conditioner display “Warning! Not enough vacuum for injection!”?
This message appears during the filling phase if the vacuum in the air conditioning system is insufficient to end the process. Check the air conditioning system or the connections between it and the AirConServiceCenter for leaks.
What does “Drained oil glass emptying!” mean on my Waeco ASC1300G display?
This message appears during the extraction or recycling process if there is more than 150 ml of used oil in the container. Dispose of the content of the used oil container in an environmentally responsible manner.
What to do if Waeco Air Conditioner displays “Quantity too large. Fill internal vessel!” message?
This message appears during the process input if there is not enough refrigerant in the internal container to complete the process. Fill the refrigerant container.
What should I do if my Waeco Air Conditioner displays “Not enough UV. Add!”?
This message appears during the filling process if there is not enough UV additive in the container to finish the process. Fill the UV additive container.
Why does Waeco Air Conditioner display “Warning! Internal vessel full!”?
The message indicates that the internal refrigerant container is too full to hold the quantity to be extracted. Drain the internal refrigerant container in the proper manner.
What to do if Waeco ASC1300G displays “Not enough oil. Add!”?
This message appears during the filling process if there is not enough fresh oil in the container to finish the process. Top up the fresh oil container with a suitable oil type.
What does it mean when my Waeco Air Conditioner displays “Warning! Pressure inside the A/C system!”?
This message appears during the vacuum process, indicating pressure in the air conditioning system. No action is needed; the process continues automatically.
Why does my Waeco ASC1300G display “Warning! Pressure inside the A/C system. Recovery start!”?
This message appears at the start of the vacuum process because there is still pressure present in the air conditioning system. No action is required as the process will continue automatically.
How to fix Waeco Air Conditioner when display shows “Printer not in line! Carry on?”?
The message indicates that the printer has a fault. Check if there is paper in the printer, ensure the printer is switched on (the yellow LED must be constantly lit), and verify that the cover is properly closed.
General| Brand | Waeco |
|---|---|
| Model | ASC1300G |
| Category | Air Conditioner |
| Language | English |
Outlines crucial safety guidelines for operating the AirCon Service Center.
Highlights specific warning symbols and their meanings related to device operation.
Describes built-in safety features like pressure monitors and relief valves.
Step-by-step instructions for the initial physical setup and powering on the device.
Step-by-step process for initially filling the device's internal refrigerant tank.
Describes the fully automatic service process using pre-defined sequences.
Explains how to set up and use personal user codes for access control.
Instructions for exporting service data and reports to a USB drive.
Describes step-by-step servicing procedures, allowing individual process selection.
Instructions for calibrating the scales used for measuring oil and UV additive.
Procedure for calibrating the pressure sensor for accurate readings.
