Name: Wagan Power Dome NX
Brand: Wagan
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Power Dome

™

NX by Wagan Tech

www.wagan.com

JUMP STARTING:

1. Review the Jump starter warnings.

2. Make sure all vehicle appliances, lights, radio, etc. are turned OFF.

3. Make sure the vehicle’s brake is set and the transmission is in park.

4. Make sure all Power Dome switches are OFF.

5. Securely connect the Red (+) cable clamp to the vehicle’s Positive (+)

battery terminal.

6. Connect the Black (-) cable clamp to vehicle chassis or non-moving, metal

vehicle component.

* If the vehicle to be started has a Positive Grounded System (positive battery

terminal is connected to chassis):

i. Connect the negative (−) black clamp to the vehicle battery’s negative

terminal.

ii. Connect the positive (+) red clamp to the vehicle chassis or a solid,

non-moving, metal vehicle component or body part. DO NOT clamp

directly to the positive battery terminal or moving parts.

7. Switch ON the Jumper Safety Switch located at the back of the Power

Dome.

8. Inside the vehicle, turn on the ignition switch and attempt to start the

engine.

9. Crank for a maximum of three seconds. If the engine does not start, wait

three minutes before the next attempt.

10. After the engine starts, turn OFF the Jumper Safety Switch.

11. Disconnect the Black Clamp ﬁrst, and then disconnect the Red Clamp.

12. Be sure that the cables and clamps are securely stored.

13. Recharge the Power Dome as soon as convenient.

NOTE: If the engine does not start, there may be a problem other than a

discharged battery. Call for roadside assistance.

Questions and Answers:

Need help?

Do you have a question about the Wagan Power Dome NX and is the answer not in the manual?

Wagan Power Dome NX Specifications

General