©2013 Wagan Corporation. All Rights Reserved.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
14
www.wagan.com
INVERTER TROUBLESHOOTING GUIDE
Trouble Cause Remedy
Lack of power output Power Dome battery
voltage below 10 volts
Recharge the Power Dome immediately
Excessive current drawn
by appliance being
operated
Reduce load to maximum of 200 watts
1. Turn OFF the device and inverter
2. Disconnect device
3. Turn the inverter ON and run for
a minimum of 2 minutes
4. Turn OFF inverter, quickly plug
in device to inverter making sure
device is OFF prior to connection
5. Turn ON the inverter and device
Inverter fuse blown Check and replace if necessary. Be sure
any replacement fuse is the same type
and rating.
Inverter Power
Indicator is not lit.
Excessive voltage drop Check Power Dome and recharge if
voltage drops below 12 volts.
Inverter is overloaded Reduce load to maximum of 200 watts.
Television/Power
Tool will not start
High surge wattage
requirement to start-up
Toggle the On/Off switch in quick
succession five times. If the device does
not start, the device is not compatible with
this type of inverter.
Television
Interference
Picture breaking up
(snow).
Place the Power Dome as far from the TV,
antenna, and coaxial cable as possible.
TV station may be out or range.
Static/noise
interference in audio
system
Sound system has weak
alternating current
shielding
Do not use inverter with low quality audio
AC filtering system.
Replace audio system with high quality
noise filtering
To Next Page
Loading...
Need help?
General
Weight and Dimensions
