SETUP
6
EN
MATERIAL PREPARATION
Material to be sprayed may need to be strained to remove any impurities in the
paint which may enter and clog the system. Impurities in the paint will give poor
performance and a poor nish.
SPRAYABLE MATERIALS WATER AND OILBASED
• Sealers
• Transparent stain
• Semi-Transparent stain
• Solid stains
• Lacquer (thinning may be necessary)
• Urethanes
• Decorative paints (thinning may be necessary)
• Furniture paints (thinning may be necessary)
• Latex and oil-based paints (thinning may be necessary)
*THINNING THE MATERIAL
Before spraying, the material being used may need to be thinned with the proper solvent as specied
by the material manufacturer. Never exceed the thinning advice given by the coating manufacturer.
If thinning is necessary, use the proper solvent as specied by the material manufacturer. Never
exceed the thinning advice given by the coating manufacturer.
Only thin the material if absolutely necessary to improve spray performance. Optimal
spray performance should be acheived simply by adjusting the various controls on
the unit.
Do not thin with materials that have a ashpoint below 100°F (38°C).
For a video showing how to set up the Control Spray, visit:
www.wagnerspraytech.com/controlspray250
To Next Page
Loading...
Need help?
General
