5
English
Round pattern
Horizontal pattern
Vertical pattern
All objects to be sprayed should be thoroughly cleaned before
spraying material on them. Areas not to be sprayed may, in
certain cases, need to be masked or covered.
The spray area must be clean and free of dust in order to avoid
blowing dust onto your freshly sprayed surface.
• Position the spray gun perpendicular to and one (1) or
more inches from the spray surface, depending upon
the spray pattern size desired.
• Spray parallel to the surface with smooth passes at
a consistent speed as illustrated below. Doing this
will help avoid irregularities in the nish (i. e. runs and
sags).
• Always apply a thin coat of material on the rst pass and
allow to dry before applying a second, slightly heavier
coat.
1 to 12 inches
Correct
Even coat throughout
Keep stroke smooth and at an even speed
• When spraying, always trigger the spray gun after spray
pass has begun and release trigger before stopping
the pass. Always keep the gun pointed squarely at the
spray surface and overlap passes slightly to obtain the
most consistent and professional nish possible.
Incorrect
Do not flex wrist while spraying.
Light coat Heavy coat Light coat
To Next Page
Loading...
