Need help?Do you have a question about the WAGNER EPG S2 FM and is the answer not in the manual?
General| Model | EPG S2 FM |
|---|---|
| Manufacturer | WAGNER |
| Operating Voltage | 230 V AC |
| Frequency | 50/60 Hz |
| Number of Zones | 2 |
| Number of Detector Loops | 2 |
| Number of Alarm Outputs | 2 |
| Operating Temperature Range | 0°C to +55°C |
| Protection class | IP30 |
| Function | Fire detection and control |
| Standards Compliance | EN 54-2 |
| Relative Humidity | non-condensing |
Details ATEX compliance and classification for explosive atmospheres.
Covers operator training, electrical safety, and safe work environment.
Includes handling spray guns, grounding, cleaning, and powder lacquer safety.
Provides detailed specifications for dimensions, electrical, pneumatic, and ambient conditions.
Covers front panel LEDs and rear connection details for EPG S2 and EPG S2 FM.
Details all connections on the rear of the EPG S2 unit.
Details rear connections for the EPG S2 FM, noting similarity to EPG S2.
Provides diagrams and instructions for connecting automatic spray guns.
Provides diagrams and instructions for connecting manual spray guns.
Details essential grounding procedures for the device and system safety.
Illustrates and describes grounding the entire powder coating system.
Explains setting the CAN bus baud rate using DIP switches.
Explains setting the CAN bus node ID using rotary buttons.
Details setting high voltage and its relationship with current flow.
Explains how to set and measure the spray current limitation.
Describes three levels for voltage/current characteristic curve settings.
Describes the simple emergency mode for system failures and its activation.
Details how to activate emergency mode using DIP switch 4.
Explains system behavior and indicators during emergency mode operation.
Critical safety warnings for maintenance and repair by qualified personnel.
Verifies grounding of conductive elements and resistance measurements.
To Next Page
