What to do if red LED (6) lights up on WAGNER VM 2000?
If the red LED (6) lights up on your WAGNER Control Unit and there's no high-voltage supply, it could be due to an open circuit in the connecting lead to the spray gun or an interrupted earth connection between the control unit and the spray gun. The connecting lead can be replaced by WAGNER Service.
How to fix green LEDs (3) (4) not lighting up on WAGNER VM 2000 Control Unit?
If the green LEDs (3) and (4) on your WAGNER Control Unit do not light up, it could be due to the mains power not being switched on or defective 0.5 / 1.6 A slow-blow fuses. Ensure the mains power supply is switched on and replace the fuses if necessary.
Why is red LED (5) lit on my WAGNER VM 2000 Control Unit?
If the red LED (5) lights up on your WAGNER Control Unit and there's no high-voltage supply, it may indicate a defective HVM-module.
General| Brand | WAGNER |
|---|---|
| Model | VM 2000 |
| Category | Control Unit |
| Language | English |
To Next Page
