EasyManuals Logo

WAGNER FLEXIO 2500 User Manual

WAGNER FLEXIO 2500
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
EN
11
PROPER SPRAYING TECHNIQUE
i
Use the images and guidelines below in order to assist you in achieving the desired spray pattern for your
project. These are meant to be general starting points - you may have to slightly modify certain controls on
the system in order to get the exact performance you need.
LARGE SURFACE PROJECTS
Generally, high material ow and air power are
needed for spraying large surface areas, such as walls
and decks.
The iSpray nozzle is ideal for these applications and
is designed for broad coverage in either horizontal
or vertical spraying.
The air cap position will determine the
movement direction of the spray gun.
SMALL SURFACE PROJECTS
Generally, low material ow and air power are needed for spraying smaller
surface areas, such as corners, lattice, or spindles.
For this type of project, reduce power, material ow and switch to a narrow
width when using the iSpray nozzle, or use the Detail Finish nozzle.
NOTES:
If you feel the material is going on too thin, increase the material ow.
If you feel the material is going on too thick, decrease the material ow even further or move the spray gun further away from
the surface.
Besides adjusting the controls, other factors that should be considered when spraying:
Distance from the spray object - if you are too far from the spraying surface, the material will go on too thin, and vice versa.
Material thickness* - if the spray pattern runs and/or is too splotchy, the material may need to be thinned.
Spray gun movement - moving the gun too quickly will cause the spray pattern to be too thin and excess overspray. Moving
the gun too slowly will cause the spray pattern to be too coarse or thick.
i
*Only thin the material if absolutely necessary to improve spray performance. Optimal spray performance
should be acheived simply by adjusting the various controls on the unit.
If the material needs to be thinned, dilute the material in steps of 5% - 10% until the desired spray pattern
is acheived.
i
If after following the guidelines on these two pages you are still not getting the spray performance you
need, refer to the ‘Troubleshooting’ section on page 15.
=
OR

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the WAGNER FLEXIO 2500 and is the answer not in the manual?

WAGNER FLEXIO 2500 Specifications

General IconGeneral
Power SourceCorded Electric
TypeAirless paint sprayer
Flow Rate1.2 l/min
Material CompatibilityStains, Varnishes
Container Capacity1.5 qt
Max. flow rate1.2 l/min
Spray TechnologyHigh Volume Low Pressure (HVLP)
Spray tipiSpray Nozzle

Related product manuals