WAGNER FLEXIO 2500 User Manual

12
EN
CLEANUP
FLUSHING THE UNIT
Special cleanup instructions for use with
ammable solvents (must have a ashpoint
above 100ºF (38ºC):
• Always ush spray gun outside.
• Area must be free of ammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
1. Unplug the power cord. Loosen the material container
by 1/2 turn, but do not remove it. This will relieve any
pressure left over in the system.
Pull the trigger so that the material inside the spray nozzle
drains back into the container.
2. Unscrew the container and remove. Empty any remaining
material back into the material container.
3. Pour a small amount of the appropriate cleaning solution
into the cup (Water=1/2 full. Mineral spirits=1/4 full).
4. Attach the cup to the nozzle and plug in the sprayer.
5. Spray the cleaning solution into a safe area.
While spraying, gently shake the spray gun. This slight
agitation will help break up smaller particles of spray
material.
6. Unplug the power cord. Loosen the material container
by 1/2 turn, but do not remove it. This will relieve any
pressure left over in the system.
Pull the trigger so that the material inside the spray nozzle
drains back into the container.
At
tention
If you cleaned the sprayer using mineral
spirits, repeat steps 1-6 using warm, soapy
water.
i
When cleaning, use the appropriate
cleaning solution (warm, soapy water for
latex materials; mineral spirits for oil-based
materials).
Move on to “Cleanup - Cleaning
the Nozzle”, next page.
1
1/2
PULL
2 3
4 5
EMPTY WASTE
CONTAINER
6
1/2
PULL

WAGNER FLEXIO 2500 Specifications

General

Power Source	Corded Electric
Type	Airless paint sprayer
Flow Rate	1.2 l/min
Material Compatibility	Stains, Varnishes
Container Capacity	1.5 qt
Max. flow rate	1.2 l/min
Spray Technology	High Volume Low Pressure (HVLP)
Spray tip	iSpray Nozzle