WAGNER FLEXIO 2500 User Manual

EN
13
CLEANUP CONTINUED
CLEANING THE NOZZLE
1. Make sure power cord is unplugged.
Push the tab below the trigger, twist and separate the nozzle from the
turbine. Wipe the exterior of the cup and nozzle until clean.
2. iSpray Nozzle only -
a. Remove the air cap (a) by prying it o the connecting nut (inset).
Loosen the connecting nut (b).
b. Remove the parts as shown. Clean all parts with a cleaning brush and
the appropriate cleaning solution.
Reassemble all parts when clean.
3. Detail Finish Nozzle only -
a. Unscrew the nut and remove the air cap and nozzle.
Remove the parts as shown(*). Clean all parts with a cleaning brush and
the appropriate cleaning solution.
Reassemble all parts when clean(**).
4. Clean the air vent (c) on the suction tube with a soft bristled cleaning
brush.
5. Clean the rear of the nozzle (d) with the appropriate cleaning solution.
Use a thin layer of petroleum jelly to lubricate the O-ring (e).
1
2
3 4
(c)
iSPRAY
DETAIL FINISH
5
(d)
(e)
(d)
(e)
iSPRAY DETAIL
FINISH
*
(*) The nozzle seal may become
stuck inside the Detail Finish nozzle
when the nozzle is removed. If this
occurs, make sure to pull it out.
**
(**) It is important that the nozzle
seal inside the nozzle be re-installed
properly. Make sure the cup side of
the seal (the side with the groove) is
facing out towards the front of the
nozzle. Improper installation will
cause leakage and damage to the
turbine.
Groove

WAGNER FLEXIO 2500 Specifications

General

Power Source	Corded Electric
Type	Airless paint sprayer
Flow Rate	1.2 l/min
Material Compatibility	Stains, Varnishes
Container Capacity	1.5 qt
Max. flow rate	1.2 l/min
Spray Technology	High Volume Low Pressure (HVLP)
Spray tip	iSpray Nozzle