English
8
Spraying Technique
Adjusting the spray tip assembly:
The adjustable spray tip assembly produces
a pattern that can be adjusted horizontally
or vertically. Rotate the spray adjustment
guard as shown.
To prevent an injection hazard,
make sure the sprayer is
unplugged before you adjust the
spray tip. Make sure the spray tip
is suciently hand tightened.
Spraying Technique
Never tip the sprayer at more
than a 45º angle when spraying
overhead. Material could get into
the motor housing and cause an
electric shock.
IMPORTANT: If material is leaking from the threads
of the spray tip, turn off the sprayer immediately or
the sprayer could be damaged. The sprayer will leak
from behind the spray tip if the atomizer valve is not
seated properly. If you notice material leaking from
this area, follow the steps below.
To Next Page
Loading...
Need help?
General
