WAGNER POWER TEX User Manual

6
English
1
. Turn the switch
O
FF (O)
a
nd unplug the power cord.
Make sure the hopper is empty of spraying material. Pour
any leftover material into a separate container. Remove
the hopper when empty.
D
O NOT attempt to
remove the hopper
from the sprayer if it
is full of material.
3. Remove nozzle from the sprayer. 4. The nozzle, sprayer and the hopper can now be hand-
cleaned using warm, soapy water and the cleaning brush
provided with the unit. Let faucet water run into the area
where the hopper connects to the sprayer. While the water
is running, activate the trigger to fully clean the nozzle area
.
DO NOT sumberge the turbine. The outside of the
turbine can be wiped clean with a damp cloth.
5. With the lubricant included with your sprayer, lubricate the
O-ring on the hopper (a) and lubricate the outer edge of
the plunger inside the rear of the sprayer housing
(b).
Pull and release the trigger a few times to distribute the
lubricant.
Cleanup
2. Unlock turbine from sprayer by turning the two halves in
o
pposite directions. The “unlock” symbol on the turbine
should come toward the guide on the sprayer. Set
turbine aside in a dry area.
6.
After all components are clean, wipe down with a dry
cloth. Reassemble the sprayer/turbine. ON/OFF switch
should be facing upward. Clean turbine labels with a
damp cloth.
Some water may flow
out the rear of the
sprayer body.
(a)
(b)

WAGNER POWER TEX Specifications

General

Brand	WAGNER
Model	POWER TEX
Category	Paint Sprayer
Language	English