WAGNER W 450 - Page 37

GB
29
W 450
Technical Data
Atomizing output: 110 W
Max. delivery rate 230 ml/min
Double insulation:
Sound pressure level*: 72 dB (A); Uncertainty K = 4 dB
Sound pressure output*: 85 dB (A); Uncertainty K = 4 dB
Oscillation level*: < 2.5 m/s²; Uncertainty K = 1.5 m/s²
Air hose length: 1.8 m
Weight: approx. 2.0 kg
* Measured in accordance with EN 60745-1
Information about the oscillation level
The specied oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Attention! The vibration emission value can dier from the specied value when the
electric tool is actually in use, depending on how the electric tool is being used. It is
necessary to specify safety measures to protect the operating personnel. These measures
are based on an estimated shutdown during the actual conditions of use (all parts of the
operating cycle are taken into consideration here, for example periods when the electric
tool is switched o, and, when it is switched on but running without any load).
Warning
If the supply cord of this appliance is damaged, it
must only be replaced by a repair shop appointed by
the manufacturer, because special purpose tools are
required.
Warning: Do not connect the blue or brown wire to the
earth terminal of the plug! The wires in this mains lead
are coloured in accordance with the following code:
blue = neutral brown = live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifiying the terminals in your plug,
proceed as follows:
Should the moulded plug have to be replaced, never
re-use the defective plug or attempt to plug it into a dierent 13 A socket. This could result in an
electric shock.
 Should it be necessary to exchange the fuse in the plug only use fuses approved by ASTA in accordance with
BS 1362. 5 Amp fuses may be used.
 To ensure that the fuse and fuse carrier are correctly mounted please observe the provided
markings or colour coding in the plug.
After changing the fuse, always make sure that the fuse carrier is correctly inserted. Without the
fuse carrier, it is not permissible to use the plug.
 The correct fuses and fuse carriers are available from your local electrical supplies stockist.