smartPRINTER Operating Instructions
smartPRINTER Operating Instructions 003/10.2017 40
[Static IP Address]: Enter the static IP address of the device.
Press the right-hand button on the directional pad and navigate to [Subnet Mask].
[Subnet Mask]: Enter the numerical code of the subnet mask in decimal form.
Press the Enter button. All entries are saved.
This concludes the settings necessary to set up the printer on a network without using a DHCP
server.
Switch the smartPRINTER on.
Launch the installation software.
Select “Install driver” from the installation menu.
Follow the steps in the driver installation program (Driver Wizard):
To Next Page
Loading...
