Reinstall Jesus bolt, apply Loctite to tip of screw or hex nut and tighten.
Level
swashplate, both rods made the same length before install, “L” control arms at 90°, and flybar paddles
also level. It'll fly smoothly. Now with the swashplate level, blade pitch at about 3-4°, the pitch control
mixing arms (35-028) should be level also. Move the throttle to where the pitch block on the mainshaft
is centered in the middle of the up/down channel in the shaft. The two lower arms will be level, while
the 2 upper arms on the flybar will be either level or slightly downward...depending on how the linkage
rods were Z-bended. With the swashplate perfectly level, just make sure you have
To Next Page
