Wallenstein BX32S - Pre-Operation Checklist

20
4�3 MACHINE BREAK-IN
Although there are no operational restrictions on
the Wood Chipper when used for the rst time, it is
recommended that the following mechanical items
be checked:
A. After operating for 1 hour:
1. Ensure the machine is in Safe Condition before
checking any components. (See Section 4.1.1).
2. Torque all fasteners and hardware.
3. Check condition of rotor bearings.
4. Check the condition and clearance of the twig-
breaker, rotor and stationary blades. Adjust or
replace as required.
5. Check for entangled material. Remove all
entangled material before resuming work.
6. Lubricate all grease ttings.
B. After operating for 10 hours:
1. Repeat steps 1 through 6 listed above.
2. Go to the normal servicing and maintenance
schedule as dened in the Maintenance Section.
4�4 PRE-OPERATION CHECKLIST
Efcient and safe operation of the Wallenstein
3 Point Hitch Wood Chipper requires that each
operator read and understand the using procedures
and all related safety precautions outlined in this
section. A pre-operation checklist is provided for
the operator. It is important for both the personal
safety and maintaining good mechanical condition
that this checklist is followed.
Before operating the Wood Chipper and each time
thereafter, the following areas should be checked
off:
Pre-Operaon Checklist
Check and lubricate the machine per the schedule
outline in the Maintenance Secon.
Check the rotor housing and discharge chute,.
Remove any blockages, twine, wire or other
material that has become entangled .
Check the condion and clearance of the twig-
breaker, rotor and staonary blades. Adjust or
replace as required.
Check that all bearings turn freely. Replace any
that are rough or seized.
Check and ensure that all covers, guards and
shields are in place, secured and funconing as
designed
Check all fasteners and ghten, and ensure your
equipment is working and in good repair.
Check that personal protecon equipment
including hard hat, safety glasses, safety shoes,
safety vest, hearing protecon and gloves are used
and in good repair.
Check that all loose fing clothing or jewellery is
not worn and loose long hair is ed back.
Check that all guards and shields are in place,
secured and funconing as designed.

Z94203
Use Your Personal
Protection Equipment