Service and Maintenance
WE225, WE235
Trailer Wood Splitter
34
8.3 Maintenance Schedule
Perform maintenance procedures at time shown or
hour interval, whichever comes rst.
As Required
Check the condition of all hydraulic lines, hoses and
ttings. Replace any that are damaged.
Remove any entangled material from splitter.
Check that all fasteners are tight.
Every 8 hours or Daily
Check fuel level See page 26
Check engine oil level. See page 25
Every 40 hours or Annually
Check hydraulic oil level. See page 25
Clean engine air lter See page 37
Inspect hydraulic oil quality See page 25
Grease frame slide, hinges,
pivot points
See page 34
Every 100 hours or Annually
Grease axle bearings See page 34
Change engine oil See engine manual
Check tire pressure
See rating on tire
sidewall
Change hydraulic oil and lter See page 36
Change engine air lter See page 37
Change fuel lter See engine manual
Clean machine. Remove debris
and entangled material.
—
8.4 Grease Points
Use a hand-held grease gun for all greasing. Pump
one shot of grease per tting.
Look for this decal on your machine. It
indicates a grease point and the interval
in hours.
• Wipe grease tting with a clean cloth before
greasing to avoid injecting dirt and grit.
• If ttings do not take grease, remove and clean
them thoroughly. Replace grease ttings as
necessary.
To Next Page
Loading...
