What to do if my Wallenstein Cables and connectors hydraulic hose is leaking?
If the Wallenstein Cables and connectors hydraulic hose is leaking, it is likely due to a worn or damaged hose. The suggested solution is to replace the hose.
How to troubleshoot slow cylinder rod movement in Wallenstein Cables and connectors?
If the cylinder rod of your Wallenstein Cables and connectors moves slowly, doesn't move, or makes screeching or hissing noises, it could be due to several reasons. There might be no hydraulic oil pressure because the oil filter is plugged (change the filter), or the hydraulic oil level might be low (add oil). The system relief pressure setting could also be too low (call a technician). Additionally, wood might be jammed around the wedge (shut off the machine and safely remove the wood), or the engine speed could be low (check that the throttle is set to maximum and that the choke is off).
What to do if Wallenstein Cables and connectors control handle won't return to neutral?
If the Wallenstein Cables and connectors control handle does not go to neutral after the rod is fully retracted, it could be due to a valve detent set too tight, requiring adjustment. Alternatively, the hydraulic oil might be too cold, in which case you should allow the machine to warm up. Another possibility is that the hydraulic fluid is contaminated, requiring you to change the hydraulic fluid and filter.
Why does the Wallenstein Cables and connectors cylinder stop when it hits the wood?
If the Wallenstein Cables and connectors cylinder stops upon contact with wood, it indicates that the second stage on the pump is not functioning. The pump may need to be serviced or replaced, so it's best to call a technician.
How to fix a jumping wedge on Wallenstein Cables and connectors?
If your Wallenstein Cables and connectors wedge jumps, it may be due to the wedge frame jamming. Lubricate the slider wear plates to resolve this issue.
Why Wallenstein Cables and connectors control handle returns to neutral prematurely?
If the Wallenstein Cables and connectors control handle goes to neutral before the rod is fully retracted, it is because the detent is set too loose. Adjustment to the detent on the valve is required.
What to do if Wallenstein Cables and connectors control handle sticks?
If the Wallenstein Cables and connectors control handle does not return to neutral when released, the control may be damaged, and it may need service or replacement. Contact a technician.
Why is my Wallenstein Cables and connectors cylinder leaking?
If the Wallenstein Cables and connectors cylinder is leaking, it is likely due to worn seals. Seal replacement may be required; call a technician.
General| Brand | Wallenstein |
|---|---|
| Model | WX370 |
| Category | Cables and connectors |
| Language | English |
To Next Page