Troubleshooting
WX370
3-point Hitch Wood Splitter
28
9. Troubleshooting
The following table lists some problems that may be
encountered, with possible causes and solutions.
If a problem persists after reading through the
Troubleshooting section, contact the local dealer,
distributor or Wallenstein Equipment. Have the
machine serial number ready.
Problem Cause Solution
Cylinder rod moves slowly or
does not move. Screeching or
hissing noise.
No hydraulic oil pressure.
Oil lter plugged. Change lter.
Low hydraulic oil level. Add oil.
System relief pressure setting too low.
Call technician.
Wood jammed around wedge.
Shut machine off and safely remove
wood.
Low engine speed.
Check throttle is set to maximum.
Check that choke is off.
Control handle does not go
to neutral after rod is fully
retracted.
Valve detent set too tight.
Adjustment required to detent on
valve.
Hydraulic oil too cold. Allow machine to warm up.
Hydraulic uid is contaminated. Change hydraulic uid and lter.
Control handle goes to neutral
before rod is fully retracted.
Detent set too loose.
Adjustment required to detent on
valve.
Control handle does not go to
neutral when released.
Control may be damaged.
Control may need service or be
replaced. Call technician.
Cylinder stops on contact with
wood.
Second stage on pump not
functioning.
Pump may need to be serviced or
replaced. Call technician.
Wedge jumps. Wedge frame jamming. Lubricate slider wear plates.
Leaking hydraulic hose. Hose worn or damaged. Replace hose.
Leaking cylinder. Seals worn.
Seal replacement may be required.
Call technician.
To Next Page
Loading...