5.0 INSTALLATION AND FIXING
VL
2
VAL.130.--.M.EN Issue: A1
09.16
19
5.2 Storage or shutdowns
Prior to installation
Avoid damp and salty atmospheres if possible. Place the valve on wooden platforms or protected from unfa-
YRXUDEOHZHDWKHUFRQGLWLRQV7KHYDOYHVLQWKHIRRGFRQ¿JXUDWLRQPRGHO)DQG3PXVWRQO\EHVWRUHGLQGRRU
Long valve shutdowns after assembly
Set the valve in safety condition before starting operation.
Before starting the valve, check the electrical and pneumatic system along with all parts whose operation may
be affected by long shutdowns.
Possible reuse after long shutdowns
Avoid damp, salty atmospheres during valve shutdowns.
Place the valve on wooden platforms, or protected from unfavourable weather conditions.
Set the valve in safety condition before starting operation.
Before starting the valve, check the electrical and pneumatic system along with all parts whose operation may
be affected by long shutdowns.
Before starting up the valve, clean it thoroughly according to the instructions given on the product safety chart.
If the valve operates in different conditions, or it uses materials different from the previous application, ensure
that the use complies to the INDICATIONS FOR USE section.
5.1 Recommendations for installation
Danger - Warning
The installation operations have to be carried out by a technician specialised in such activities
Provide appropriate safety measures and use suitable equipment to prevent risk of work accident to the
persons involved in the operations and to those nearby.
Harness and handle the valve concerned as described and shown in the ³Unloading and lifting meth-
od´ paragraph.
%HIRUHVWDUWLQJLQVWDOODWLRQ GH¿QH DVDIHW\SODQZKLFKFRPSOLHV ZLWK WKHODZVLQIRUFHUHJDUGLQJ ZRUNSODFH
safety.
The specialist technician, authorized by the installer or owner, has to evaluate whether the area has been pre-
pared properly and whether the necessary installation equipment is available (crane, etc.).
'H¿QHRQWKHEDVLVRIWKHFRQ¿JXUDWLRQRIWKHYDOYHFRQFHUQHGWKHDVVHPEO\PHWKRGLIWKHJHDUUHGXFHUDQG
electric motor require preassembly.
Clean the coupling surfaces thoroughly.
To Next Page
Loading...
Need help?
General
