5.0 INSTALLATION AND FIXING
VL
2
VAL.130.--.M.EN Issue: A1
09.16
33
2) Fit the inductive sensor D.18 to the valve by using the appropriate bores.
3) Adjust the sensor on the basis of its reading / operation features.
4) Tighten the nut of the inductive sensor.
5) Check the operation the prior to starting regular operation.
6) Repeat the operation for the second limit switch, if required.
ADJUSTABLE SEAL SYSTEM
The valve is equipped with a seal adjusting system meant to vary the blade - gasket gap; this allows restoring
/ increasing the dust sealing in case of particularly thin dust or partial wear of the sealing gasket.
To Next Page
Loading...
