Continuous Drainage
- When you plan to leave this unit unused for a long time, please remove the rubber blockage from the
drainage hole at the bottom of unit, and drain all water outside.
- The continuous drainage is not need to be applied when the unit working at the COOL or DEHUMIDIFY
mode. The unit can evaporate the condensate water automatically by the splash motor. Make sure the
drainage holes are stemmed well.
- If water splash motor is damaged, continuous drainage can be used. To connect the drain hose to the
bottom drain hole, the unit can also work well.
- If splash motor is damaged, intermittent drainage can also be used. Under this condition, when the
water full indicator lights up, please connect a drain hose to the bottom drainage hole, then all the
water in the water tank will be drained outside. The unit can also work well.
7. Installation Explanations
1. Installation Explanations:
- A removal air-conditioner shall be installed in the flat and empty place all around. Don’t block the air
outlet, and the required distance around should be at least 12 inches.
- Should not be installed in wet location, such as the laundry room.
- Socket wiring should be in accordance with the local electric safety requirements.
2. Introduction to Exhaust Hose Installation
A) Temporary installation
1. Twist the housing adaptor and the window Connector to the ends of the exhaust hose.
2. Insert the fixing clip of the housing adaptor into the openings at back of the air conditioner.
3. Put the other end of the exhaust hose to the near windowsill (see Fig.4).
7. Installation Explanations
To Next Page
Loading...