EasyManua.ls Logo

WANAI WAP1-08BC - Air Filter Maintenance; Cleaning the Unit Surface; Troubleshooting; Start-up and Cooling Problems

WANAI WAP1-08BC
22 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
1) Before cleaning, be sure to disconnect the unit from any electric supply outlet;
2) Do notusegasolineorotherchemicalstoclean theunit;
3) Do not wash the unit directly;
4) If the conditioner is damaged, please contact the dealer or repair shop.
1. Air Filter
- If the air filter becomes clogged with dust/dirt, the air filter should be cleaned once every two weeks.
- Dismounting
Open the air inlet grille and take off air filter.
- Cleaning
Clean the air filter with neural detergent in lukewarm104℉)and dry it up in the shade.
- Mounting
Putting the air filter into the inlet grille, replace the components as they were.
2. Clean the Air-conditioner Surface
First clean the surface with a neutral detergent and wet cloth, and then wipe it with a dry cloth.
9. Troubleshooting
Troubles
Possible Causes
Suggested Remedies
1.Unit does not start
when pressing on/off
button
- Water full indicator lamp blinks, and
water tray is full.
Dump the water out of the water
tray.
- Room temperature is higher than
the setting temperature. (Electric
heating mode)
Reset the temperature
- Room temperature is lower than the
setting temperature. (Cooling mode)
Reset the temperature
9. Troubleshooting