WAREMA WMS - Legal notes

7
890374_b•en•01.09.2014
We reserve the right to carry out improvements
Button/
display
Action/result
 Select the desired product and change
its position using the UP/STOP/DOWN
buttons.
 Using the scene button, select the scene
channel again.
E.g.
 The LED below the scene channel lights
up.
 Press the comfort button for approx.
5seconds.
 The transmission LED lights up for 2
seconds
GREEN: The position of all receivers is
stored
RED: Not all receivers could be
reached; press the comfort but-
ton again.
Deleting scenes
In the following example, a scene (e.g. scene2) is de-
leted.
Button/
display
Action/result
 Select the scene channel that you would
like to delete.
E.g.
...
 The LED below the selected channel lights
up (in the example, channel2).
 Press the scene button for at least 10sec-
onds.
 The display changes to the normal product
display.
 The scene is deleted.
OTEN After the last scene has been deleted, the
scene button no longer lights up.
Commissioning functions
Learning in (scanning)
Before WMS receivers can be operated via a hand-held
transmitter, they must be included as a component in the
respective radio network. A hand-held transmitter can
detect WMS receivers and sensors and add them to its
network.
AUTIONC
When learning in, it is important that you
select the product type of the connected
product. Selection of the wrong product type
can lead to malfunctions and may result in
damage to the connected product.
Button/
display
Action/result
 Wake up the hand-held transmitter with
any product button
 Press the learn button for approx. 5 sec-
onds
+  lights up in green; the transmission
LED flashes. For several seconds, the
hand-held transmitter scans the range for
receivers.
Button/
display
Action/result
E.g.
 When the scanning procedure is complet-
ed, the located receivers are displayed in
the upper row of LEDs (here, for example,
2 receivers).
RED: New receiver
GREEN: The receiver already belongs to
the network
Receivers that already belong to a differ-
ent network are not located during scan-
ning.
 Using the arrow keys, select the desired
receiver.
(You can use the button to check
which receiver is currently selected. The
product waves.)
E.g.
 The LED of the selected receiver flashes.
For new receivers, all product buttons to
which the receiver can be assigned flash.
 Select the product type and channel into
which the receiver is to be learned
E.g.
 The LED of the selected receiver flashes in
red. The selected product button flashes,
and the current channel is displayed in the
lower row of LEDs.
 Press the button
E.g.
 The LED of the selected receiver flashes in
green. The receiver has been learned into
the hand-held transmitter.
You can now add additional scanned products in the
same manner:
 Briefly press the learn button to leave the
learn mode.
OTEN If the hand-held transmitter is still in its deliv-
ered state (no products have been learned in
yet),
lights up in red for 1 minute after the
transmitter wakes up.
Once the product type has been selected, it
can no longer be changed directly. To program
a WMS plug receiver for another product type,
the receiver must be deleted out of the network
entirely and learned in again.
Deleting products from the network
You can completely delete a product from the network if
you decide to remove the product or assign it to a different
network.
In the following example, the second detected receiver is
deleted from the network.
Button/
display
Action/result
 Wake up the hand-held transmitter with
any product button
 Press the learn button for approx. 5 sec-
onds
+  lights up in green; the transmission
LED flashes. For several seconds, the
hand-held transmitter scans the range for
receivers.