3
SAVE THESE INSTRUCTIONS
APPROVED FOR COMMERCIAL USE
GROUNDING INSTRUCTIONS
For your protection, this appliance is equipped with a 3-conductor cordset.
120 volt units are supplied with a molded 3-prong grounding-type plug (NEMA5-15P), and should be
used in combination with a properly connected grounding-type outlet as shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in Figure 2, may be obtained to
enable a 2-slot wall outlet to be used with a 3-prong plug.
As shown in Figure 3, the adapter must be grounded by attaching its grounding lug under the
screw of the outlet cover plate.
CAUTION: Before using an adapter, it must be determined that the outlet cover plate screw is
properly grounded. If in doubt, consult a licensed electrician. Never use an adapter unless you are
sure it is properly grounded.
NOTE: USE OF AN ADAPTER IS NOT PERMITTED IN CANADA. 220–240 volt “GS Safety
Approved” units are supplied with a molded European grounding-type plug (CEE 7/7).
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
