19
• Allow unit to cool for 30 minutes.
• Reassemble unit, and run rst with the bowl empty, then put
food into the bowl and try again.
Unit jams or vibrates excessively
• Turn unit off and unplug.
• Disassemble the batch bowl/accessories.
• Make sure there is no food in S-blade hub (if applicable).
• Clean food off accessory discs (if applicable).
• Reassemble unit, and run rst with the bowl empty, then put
food into the bowl and try again.
Unit will not come up to full speed
• Bowl is overloaded – remove food being processed and reload
using smaller quantities.
If unit does not operate after you have
followed the above
• Check outlet to be sure there is current.
• Check to be sure circuit breaker is on.
• Check to be sure the fuse is not blown if there are fuses on this
circuit.
• Call local Waring service agency.
If food processor makes grinding noise
• Turn unit off, unplug, disassemble, check bowl and blade to
see if they have been rubbing together.
• If bowl and blade are rubbing, call your authorized Waring
service agency.
CLEANING AND MAINTENANCE
Clean the food processor and accessories prior to initial use and
after each use. Do not use harsh abrasive-type cleaners on any
part of the food processor.
Wash the motor shaft with a small brush.
Wash, rinse, sanitize and dry the bowl, cover, small food pusher,
large food pusher, accessory discs, and S-blade prior to initial
To Next Page
Loading...
