What to do if my Warmhaus Boiler shows error E 16?
If your Warmhaus Boiler displays error E 16, it indicates the central heating RETURN temperature sensor is faulty. To attempt a fix, reset and restart the boiler. If the issue persists, it is recommended to call an authorized service.
What to do if my Warmhaus Enerwa Plus 2530 Boiler shows error E 14?
If your Warmhaus Boiler displays error E 14, it means the central heating FLUE temperature sensor is faulty. You can try to reset and restart the boiler. If the problem continues, call an authorized service.
What to do if my Warmhaus Boiler shows error E 21?
If your Warmhaus Boiler displays error E 21, it indicates a lack of water in the system, pump blockage, pump failure, pump harness issue, or installation blockage. First, RESET boiler and check if problem removed. Check boiler central heating valves are open if they are closed open all. Check all radiator valves are open if they are closed. Minimum 3 meters of radiator must be open. RESET boiler and check if problem resolved. If the issue persists, call an authorized service.
What to do if my Warmhaus Boiler shows error E 20?
If your Warmhaus Boiler displays error E 20, this indicates a lack of water in the system, pump blockage, pump failure, pump harness issue or installation blockage. Begin by resetting the boiler to check if the problem is resolved. Ensure the boiler's central heating valves are open; if closed, open them. Check that all radiator valves are open, with a minimum of 3 meters of radiator open. Reset the boiler again and check. If the issue persists, call an authorized service.
What to do if my Warmhaus Enerwa Plus 2530 shows error E 03?
If your Warmhaus Boiler is showing error E 03, this indicates high water pressure in the boiler (greater than 2.8 bar). Initially, check the filling tap of the boiler and ensure it is closed. During boiler operation, the safety valve may continue to drain water, so ensure it's connected to a drain line. If your plumbing line has a drain cock, turn the boiler off and let the pressure drop to 1-1.5 bar, then switch it on again. If the pressure increase reoccurs, call an authorized service.
What to do if my Warmhaus Enerwa Plus 2530 shows error E 07?
If your Warmhaus Boiler displays error E 07, it indicates a lack of water in the system, pump blockage, pump failure, pump harness issue, or installation blockage. First, reset the boiler to see if the problem resolves. Check that the boiler's central heating valves are open; if they are closed, open them. Also, ensure all radiator valves are open, with a minimum of 3 meters of radiator open. Reset the boiler again and check. If the issue persists, call an authorized service.
What to do if my Warmhaus Enerwa Plus 2530 Boiler shows error E 02?
If your Warmhaus Boiler displays error code E 02, it indicates that the water pressure in the boiler is too low. First, fill the boiler to a pressure of 1.2-1.5 bar, according to the manual. Then, check that the system pressure is within 1.2 - 1.5 bar on the LCD screen. Reset and restart the boiler. If the problem persists, call an authorized service.
What to do if my Warmhaus Boiler shows error E 04?
General| Type | Combi Boiler |
|---|---|
| Fuel Type | Natural Gas / LPG |
| Ignition Type | Electronic |
| Flue Diameter | 60/100 mm |
| Operating Pressure | 3 bar |
| Efficiency | 93% (at 30% power) |
To Next Page
