What to do if my Warmhaus EWA 2530C Boiler shows error E 02?
If your Warmhaus Boiler displays error code E 02, it indicates that the water pressure is too low. First, fill the boiler to reach a pressure of 1.2-1.5 bar as indicated in the manual. Check the system pressure on the LCD screen to ensure it reads between 1.2 and 1.5 bar. Then, reset and restart the boiler. If the problem continues, contact an authorized service for assistance.
What to do if my Warmhaus EWA 2530C shows error E 03?
If your Warmhaus Boiler shows error E 03, it means the water pressure is too high (above 2.8 bar). First, verify that the boiler's filling tap is completely closed. During operation, ensure the safety valve is connected to a drain line in case it drains water. If your plumbing has a drain cock, turn off the boiler, allow the pressure to drop to 1-1.5 bar, and then turn it back on. If the pressure continues to increase, contact an authorized service.
How to fix Warmhaus EWA 2530C error E 01?
When your Warmhaus Boiler displays error code E 01, it indicates a fault with the flue sensor. Try resetting and restarting the boiler. If the issue persists, call an authorized service for assistance.
To Next Page
General
