Operation
Buzzer Control
The buzzer will sound when a command is made using the remote.
Single buzz - When the user sits down and the sensor is activated, the buzzer will sound once.
Buzz twice – when operation is attempted when the user is not seated.
Buzz three times – The Washloo has detected a fault – please refer to troubleshooting manual.
Remote Control Matching
1. Turn the entire Washloo off using the side control knob.
2. Press the ‘Weak’ and ‘Rear Wash’ button at the same time and hold until the remote control
indicator light flashes.
3. Turn the power on to the Washloo using the side control within 5 seconds of the previous
step.
4. This will match the code between the remote control and the Washloo Unit (indicator light
will stop flashing on the remote).
Press and hold
Press Side Control Power
on within 5 seconds
12
To Next Page
Loading...