Installation Guide
Installation Environment
1. Prior to installation, ensure the Mains Pressure and Flow Rate is
adequate to support the Washloo Supremes’ minimum requirement.
2. Please note - A minimum of 2 bar static water pressure is required and
a minimum flow rate of 5 Litres in 18 seconds (17 l/min) minimum.
3. Only use mains water supply. Do not use tank fed water, industrial water
or grey water for the supply as this may cause skin damage or disease.
This may also block the filters located within the T-Piece quickly (Hard
Water Areas).
4. Use the supplied T-Valve/Filter to ensure the Washloo is correctly
protected against contaminated/hard water. In hard water areas it is
advisable to use an inline water softener.
5. ‘Do Not’ connect the Washloo to the power supply before the
installation is complete.
Installation Conditions
13
Drain Outlet Distance 28.5cm
1. The distance from the wall to
the centre of the Drain
Outlet is 28.5cm
2. The Washloo Supreme is a
vertical waste outlet.
Accessories for Installation
Seal Ring
Braided Hose
Angle
Valve/Filter
Spanner
User Manual
To Next Page
Loading...