Getting Started
Wearing the center V300 Camera chest mount
To use the chest mount:
1. Separate the under-shirt bracket from the over-shirt bracket:
a. Hold the under-shirt bracket in one
hand with the thumb on top and the
two middle fingers on the bottom.
b. Raise the levers on both sides.
c. Pull the front and back apart.
d. While holding the levers up, pull the
brackets apart.
2. Match the anchor tabs and camera slots
on the over-shirt bracket with the back of
the camera—keeping the magnets apart.
You can attach the camera before or after the mount is in place.
3. Place the under-shirt bracket under your shirt where you want to wear
your camera.
4. Line up the anchor slots and place the over-shirt bracket against the
under-shirt bracket, with your shirt between them. (These will snap
together forcefully.)
8
WatchGuard V300 Camera
Quick Start Guide
WGD00170 Revision: B
To Next Page
Loading...