To Next PageTo Next Page
Need help?Do you have a question about the Water Specialist WS1TC and is the answer not in the manual?
Initiates regeneration immediately by pressing and holding specific buttons.
Schedules regeneration for tonight by pressing and releasing specific buttons.
Illustrates water flow during normal and bypass operational states.
Guides on resetting the time of day after a power outage.
Explains how to set regeneration time and frequency between cycles.
Describes two options for regeneration frequency: days between or specific days of the week.
Details ten programming options for various cycles like backwash, regenerate, rinse, and fill.
Procedure to configure the control valve system for OEM installation and setup.
Overview of settings accessible by installers, including regeneration options.
Overview of information shown to the end-user regarding system status.
Configures the number of days (1-99) between regeneration cycles.
Sets the current day of the week for scheduled regeneration.
Shows display alternation between time and days remaining before regeneration.
Indicates current regeneration cycle step and time remaining during regeneration.
Instructions for initiating manual regeneration immediately or at a delayed time.
Explains time of day reset needed after power loss exceeding 8 hours.
Describes error codes (E1-E4) indicating potential valve malfunction.
Lists parts for the front cover and drive assembly with order numbers and diagrams.
Details components of the WS1TC drive cap, piston, and spacer stack with part numbers.
Details components of the WS1.25TC drive cap, piston, and spacer stack with part numbers.
Illustrates how to identify valve models based on distributor tube opening size and color coding.
General| Category | Control Unit |
|---|---|
| Model | WS1TC |
| Manufacturer | Water Specialist |
| Operating Temperature | 0-50°C |
| Protection Rating | IP65 |
| Dimensions | 160 x 120 x 95 mm |
| Weight | 0.8 kg |
