WaterRower ComModule User Manual

Please note the Com Module is connected within the individual App i.e
WaterRower Connect and not via the Bluetooth setting on your device.
Kérjük, vegye figyelembe, hogy a Com Module az egyedi alkalmazáson belül
csatlakozik, pl
A WaterRower Connect nem a készülék Bluetooth-beállításán keresztül.
Please retry the steps below. Usually if the ComModule doesn’t turn off the
connection would not have been initially made between the S4 monitor and the
ComModule device at the start. i.e the PC icon would not have appeared on the
display.
Kérjük, próbálja meg az alábbi lépéseket. Ha a ComModule nem kapcsol ki, általában
nem jön létre a kapcsolat az S4 monitor és a ComModule eszköz között, azaz a PC
ikon nem jelenik meg a kijelzőn.
1. Attach the Com Module to S4 monitor:
Csatlakoztassa a Com modult az S4 monitorhoz:
2. Press the ‘On’ button on the S4 monitor
Nyomja meg az „On” gombot az S4 monitoron
3. Press the button down on the top of the Com Module.
Nyomja meg a gombot a ComModule tetején.

WaterRower ComModule Specifications

General

Connectivity	Bluetooth
Connection Type	Wireless
Power Source	Battery
Battery	CR2032 coin cell
Compatibility	WaterRower models with S4 monitor
App Compatibility	WaterRower Connect, third-party fitness apps

Summary

Connecting the WaterRower Com Module

Physical Attachment and Power On

Attach the Com Module to the S4 monitor and press the 'On' button.

Com Module Activation

Press the button on the top of the Com Module to activate it.

Establishing the Connection

Verify PC Icon and Troubleshooting

Check for the PC icon on the S4 monitor; troubleshoot if it's absent.

Com Module Status and App Launch

Note the ComModule flashing blue and open the Connect app to 'Start Rowing'.

Mobile App Pairing and Mode Selection

Device Scanning and Confirmation

Allow the mobile device to scan and confirm connection to the WaterRower.

Choosing Your Rowing Mode

Swipe on the app to select the desired rowing mode.

Starting and Monitoring Your Row

Initiate and Set Rowing Time

Press 'Start' and adjust the rowing duration on the mobile app.

Begin Rowing Session

Start the actual rowing by pulling the handle on the machine.

Real-time Performance Tracking

Monitor Output on App and Monitor

View real-time rowing data on both the S4 monitor and the mobile application.

Completing and Saving Your Workout

Save or Dismiss Workout

Save or dismiss the workout summary in the app after finishing.

Proper Disconnection Procedure

Turn off the Com Module by holding the button for 5 seconds before removing it.