Watersnake
6
WATERSNAKE ELECTRIC MOTORS
Congratulations and welcome to a world of silent motoring.
Powerful yet silent, the Watersnake electric motors are built to suit all angling
conditions. High quality materials, superior design and precision engineering
make these motors longwearing and reliable.
Please read manual completely before starting installation.
ATTACHING THE MOTOR TO YOUR BOAT
Attach the motor to the bow of the boat, taking care to ensure the motor is
on the centreline of the boat and forward enough to avoid the shaft making
contact with the boats gunwale rubber. With the motor in position, mark the
holes for drilling, ensuring as you do that the bow area below the mounting
location is clear and accessible.
Mount the plate to the bow using stainless steel bolts, nuts and washers.
It is important when doing this work that the boat is level and the motor is
mounted level.
Remove covers to expose
Mounting Plate.
After the Motor is Mounted
replace covers.
Watersnake Distribution Pty Ltd accepts no liability
for personal injury or property damage caused while
drilling/mounting this motor. Please wear appropriate
protective clothing and eyewear/ face shield.)
If you do not want your motor attached to the bow
of your boat at all times it is recommended that you
purshase aJarvis Marine quick release bracket.
OPTIONAL QUICK RELEASE BRACKET (Sold Seperately)
You can also mount your motor using a Jarvis Marine Quick release bracket,
which allows you to easily attach or remove the motor to your boat, for
transport and storage. Full mounting instructions are included with the
brackets.
PLEASE NOTE:
Nylon
Quick Release
Bracket JM55007
To Next Page
Loading...
Need help?
General
