WaterSoft ISOBAR III - Programming the Control Valve

12
Main Menu
12:00
1. To enter Main Menu, press the Menu/Enter button.
(Time of Day will ash)
2. To set the Time of Day, press the Set/Change button.
(First digit will ash) Example [12-00]
- To change digit value, press the Set/Change button.
- To accept the digit value, press the Menu/Enter button.
- Next digit will ash to begin setting.
- Once the last digit display is accepted, all digits will ash.
3. To set A.M. or P.M ., press the Menu/Enter button.
- To change digit value, press the Set/Change button. Example [ A ]
- To accept the digit value, press the Menu/Enter button.
- Once A.M. or P.M. is accepted, the next menu item will ash.
4. A. To set Hardness an “H” will appear to enter Compensated Hardness in grains per gallon (gpg)
Default setting is 25 gpg. Example [ H - 25]
5. To Exit Main Menu, press the Menu/Enter button.
Note: If no buttons are pressed for 60 seconds, the Main Menu will be exited automatically.
Programming the Control Valve
- Programming The Control Valve -
1. Set time of day.
2. Set a.m. or p.m.
3. Set Hardness (grains per gallon).
Note: Salt settings are pre-set at the factory for the maximum shown on the capacity charts.
Warning: Do not reduce salt settings below 9 lbs. as the water level in the brine tank will not reach the grid
plate.