Need help?Do you have a question about the Watson Marlow Pumps qdos 60 and is the answer not in the manual?
General| Brand | Watson Marlow Pumps |
|---|---|
| Model | qdos 60 |
| Category | Water Pump |
| Language | English |
Details technical specifications for pump flow rate, power, and environment.
Lists materials for fluid path components in pumpheads.
Step-by-step guidance for installing the pump safely and correctly.
Instructions for connecting the pump to an AC mains power supply.
Details pin assignments for M12 connectors on the pump.
Details pin assignments for the pump's output connectors.
Guidance on wiring connections to the relay module terminals.
Instructions for installing the pump in a PROFIBUS network.
Details pin assignments for the PROFIBUS M12 connector.
Steps for initial power-up and language selection.
Explains keypad functions for manual pump operation.
Steps to set the pump's station address in PROFIBUS mode.
Steps to calibrate the pump for 4-20 mA analog control.
Configuration settings for the pump's contact mode.
How to enter and operate the pump in contact mode.
What happens when a leak is detected and troubleshooting steps.
Lists error codes and suggested actions for internal errors.
Steps for removing and replacing the Qdos 30 pumphead.
Instructions for connecting tubing to the ReNu 30 pumphead.
Steps for removing and replacing pumpheads for other models.
Instructions for fitting fluid port seals on pumpheads.
To Next Page