3 Seven User Guide | INS-SVN-USER | watsonfurniture.com
CARE + MAINTENANCE
We recommend that you not allow any of the following
reagents to remain in contact with the laminate:
• Hypochlorite bleach, except as described in
this manual
• Hydrogen peroxide solution
• Mineral acids, hydrochloric acid (i.e. Lime-A-Way™),
sulfuric or nitric acid
• Caustic solutions containing greater than 2% lye,
(i.e. Drano®)
• Sodium bisulfate, such as Sani-Flush®
• Potassium permanganate
• Berry juices
• Silver nitrate, in 1% concentration or greater
• Gentian violet
• Mild silver protein, such as 20% Argyrol
• Bluing
• Fabric dye, such as Tintex® or Rit®
• Alcohol containing 1% iodine in solution
Fabric Panels
Fabric may be cleaned with mild, water-free solvents or
water-based cleaning agents or foam. For tough stains,
we recommend Shout® wipes as an eective cleaner.
Storage
When not in use for an extended period of time,
always unplug this furnishing from the electrical
outlet and carefully stow the power cord to avoid
accidental damage.
WARNING
Always rinse laminate surfaces after cleaning. Cleaning
solutions may leave behind a residue that can be
reactivated by moisture from cups or drinks. Prolonged
exposure to cleaning residues can cause permanent
discoloration, scars, or stains in laminate surfaces.
CAUTION
For normal cleaning, vacuum panel fabric as needed,
using an upholstery attachment. Do not brush fabric or
use a vacuum attachment with a rotary brush. Brushing
may permanently damage the nap or change the
character of the fabric.
Surface & Case Laminate
To clean the surface, use mild soap or detergent
with a damp cloth or sponge. Dicult stains such as
coee or tea can be removed by using mild household
cleaner and baking soda; mixing to achieve a paste
consistency. Gently wash (approximately 15-20 strokes)
the aected area using a sti nylon bristle brush. Do not
scrub so as to scratch the surface finish. Avoid cleaners
with ammonia.
Marker Board Laminate
Wilsonart Marker Board Laminate can be cleaned using
a felt or multi-purpose board eraser. When additional
cleaning is required, a soft cloth dampened with warm
tap water and mild soaps, such as those used for hands
or dishes, is recommended. Remember to clean erasers
often by wiping to remove dry-erase marker residue.
Stubborn Stains
Stubborn stains that resist any of the mentioned
cleaning methods may require the use of undiluted
household bleach or nail polish remover. Use a cotton
ball saturated with bleach or nail polish remover
(acetone), gently rub the stain for up to two minutes.
Rinse thoroughly with warm water and wipe dry with
a soft cloth. This step may be repeated if the stain
appears to be going away and the color of the laminate
has not been aected.
Note — Scrubbing too hard or at length can damage
the surface finish.
If stubborn stains persist, Marker Board Laminate can
be cleaned with spray-type glass cleaners, such as
Windex®.
Do not use cleansers that contain abrasives, acids or
alkalis; they will damage the surface. Remove stubborn
stains with a 2-minute exposure to hypochlorite bleach,
such as Clorox®, followed by a clean water rinse.
To Next Page
Loading...
Need help?
General
